Save 40% on all orders until end of November with code BlackNovember*  - Order now

Lack of sound or poor sound quality

Lack of sound is typically due to blockages in your firewall or errors in your broadband router. Poor sound quality is almost always due to poor internet connection.

Crackleling or choppy sound

This is typically a sign of too little bandwidth or packet loss on your broadband connection. If you hear cracks, it's your downstream speed and if others hear them, it's your upstream speed, which is usually the problem.

Is your internet connection good enough?

Virtually all internet connections in developed countries are so good that they can be used with IP telephony without any problems. Try our test and read more

Solutions

 

  1. Check RTP settings
    If you have Cisco, Linkys or Sipura equipment, make sure "RTP Packetsize" is set correctly according to our guides.
  2. Close programs that generate traffic
    These can be file sharing programs, viruses (remove), etc. that send data to the internet. (See also point 5).
  3. Check for packet loss
    At a command prompt (Start -> Run, then type "CMD" and press [ok]. Enter: "ping -t voice.redspot.dk". Let it run for a minute or more. Stop the test with CTRL-C. Package loss must be 0%. Measure at the times when there is the most load, which is typically between 18.00 and 20.00 on weekdays. Contact your provider if the value is above 0%.
  4. Check your bandwidth
    See the section "Is my internet connection good enough?" above.
  5. Use Quality of Service (QoS)
    Use a router or adapter that supports QoS and can prioritize your voice traffic.
  6. Change your CODEC settings
    Typically, the G711 is also called ULAW / ALAW / PCMU / PCMA by default in your adapter or phone. This CODEC provides the best sound quality, uses the most bandwidth and is therefore sensitive. Read more about CODEC's under "Frequently Asked Questions".

    Solution, Linksys and Sipura
    Under "Line 1", "Audio Configuration set

    Preferred Codec: "G729a"
    Use Pref Codec Only: "Yes" (only if you use Clearwire *)

    *) A few IP phones do not support G729 and you will thus not be able to talk to people who use these, including Xten X-Lite. In addition, you may experience problems with calls to IP phones that forward to voice mail.

    Solution others
    Select G729 or iLBC as the first priority or option. In Counterpath X-Lite 2.0, deselect a CODEC by clicking on it in the display so that it turns light gray.

    Note
    It is impossible to fax via anything other than G711A / U. However, Cisco, Linksys, and Sipura adapters will normally recognize fax calls and automatically switch to the G711. Choosing CODECs with compression (all other than G.711A / U) also carries a greater risk of echo.

    Read more about CODECs under "Frequently Asked Questions".

Help Topic HT040053. Published 26 August 2004. Updated 12 September 2023.

Get started with Redspot IP Telephony

Become well equipped to use Redspot IP telephony. Learn more

FAQ

Answers to frequently asked questions. Learn more

No dial tone? Can't register?

Solutions to typical technical problems. Learn more

Service status

Details about service issues and planned maintenance. Learn more